PPM 300 Shaft generator controller

Customizable shaft generator controller designed for efficient power management

Contact us
PPM 300 (Bus Tie Shaft Generator Shore Connection) PPM 300 Display Back PPM 300 Display Bottom PPM 300 Display Top PPM 300 Display Side PPM 300 Rack 4Units Front Codesys PPM 300 Rack 7Units Front

The PPM 300 Shaft generator controller variant controls and protects the system when a shaft generator is connected, and it controls and protects the shaft generator breaker.

When a shaft generator is connected, it is normally the ship's only power source, but it can run in parallel with the gensets and supply a base load for an extended period (long-time parallel). In such cases, the PPM 300 Shaft generator controller works with the PPM 300 Genset controllers to ensure efficient power management.

A DEIF power management system can include as many Shaft generator controllers as necessary.

Recommended I/O modules

Slot 1

Slot 2

Slot 3

Slot 4

Slot 5

Slot 6

Slot 7

PSM3.1

ACM3.1

IOM3.1

Blind module

Blind module

Blind module

PCM3.1

The table shows a 7-slot rack, but the controller is also available with a 4-slot rack. Modules PSM3.1, ACM3.1, and PCM3.1 are mandatory. If you add expansion module racks, each expansion rack must contain a PSM3.2 power supply module but does not need to contain other modules.

For general information about the PPM 300 controller range and its modular architecture, see the PPM 300 main page.

Other PPM 300 variants

Genset controller

Emergency genset controller

Shore connection controller

Bus tie breaker controller

Hybrid (battery) controller

Read more

Product videos

Products

Installing the display unit (DU 300)

Introduction to the display unit (DU 300)

Introduction to the PPM 300 controller rack

Protection and Power Management (PPM 300)

Unboxing the display unit (DU 300)

Unboxing the PPM 300

Tutorials

Installing the Multi-line 300 controller rack

Cases

Ferry saves 30 % on fuel consumption